Jump to content

Recommended Posts

Hi All

Recently purchased a Mk2 GT6.  Bodywork and paint all done but needs finishing.  Currently fitting a new loom and everything going ok until tried to wire in heated rear screen.  Ive linked the new loom to the existing loom under the headlining and there are 2 wires (one at each hinge) but no wires from the heated screen to plug these into.  It looks like someone has fitted a new rear screen without exiting the relevant wires from the heating element.  However, not really sure how this is done - from under the seal?  if not where? Am i missing something?

thanks in anticipation




Link to post
Share on other sites
  • 1 year later...

Hi Bob,

Not sure I understand the exact problem you have but, if it is of help and the connections are missing off the actual screen you can buy conductive silver epoxy which you can use to attach a spade terminal for the wire. you can also use it if you mask off carefully to repair individual broken element as they are normally on the surface and not embedded, as with modern heated glass. It's not cheap but available from RS or Farrnell but cheaper than another glass I suspect.

I expect you have this well resolved by now!

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Create New...