Trading Area

Wanted: Spitfire 1500 Seats

Sun, 06 May 2012 09:33:16 +0000

Preferably in reasonable nick, a few tears/rips I can deal with, no foam I can't! Will pay up to about £50, but preferably less (current seat of seats were £15 and have 1 rip in).

Cheers, Aaron

Electric Spitfire

Sat, 05 May 2012 13:29:31 +0000

I know we are all petrol heads but still interesting......

Nick

Spit 1/2/3 F/g Bootlid And Front Valance

Fri, 04 May 2012 09:46:24 +0000

Both new but undrilled/unfitted but garage scuffed. having a major garage clearout. £50 for the bootlid and £20 for a front valance.

cheers
matt

For Sale Spitfire Oil Cooler Kit

Tue, 01 May 2012 05:26:11 +0000

Hi guy's £60 for this oil cooler stuff. Been sat in my shed for quite a bit now so will need a flush. Change of plans is why I'm selling.

Chris.

For Sale - Rover K Series 55Mm Alloy Throttle Body

Thu, 26 Apr 2012 11:56:36 +0000

A k series 55mm alloy throttle body in clean usable condition, although the TPS is untested. It has been converted to throttle cable operation. I purchased this off ebay about 3 years ago for an efi project, the throttle cable conversion was carried out by the seller. £35 inc p+p.

Attached Images

Eaton 45 Super Charger

Tue, 24 Apr 2012 20:09:21 +0000

Eaton 45 super charger for sale.

Unsure what this came off although I am led to believe it came off of a BMW Mini Cooper s which had a conversion done to it.

I brought this with the intention of using this on my Spitfire but I think it’s too small for a 2.5 with the boost pressure I wanted.

The supercharger is 2nd hand but all looks good. I can’t test it but it makes no noises and the pulley is in good straight condition.
Can post a photograph if required.

Cost me 205 GBP but I am open to offers as I don’t require it and it must gooooooooo.
Iain.
I am in Burnley, Lancs until Saturday and then off to Burma for 8 weeks.

Quaife Rear End .

Mon, 23 Apr 2012 21:45:30 +0000

I am toying with selling my current rear drive train to fund the remainder of my Subaru/MGF conversion .
Includes all unrun ;
Alluminium housed Quaife 3.63 diff ,
Canley CV's,
Ally uprights ,
Ally wishbones ,
Polybushes ,
All complete newly prepared by Canley GT6 drums ,
New bearings ,
New trunnions .
New handbrake kit .
Improved studs .
To buy new about £2100.00 without labour or postage .
Could loose say £800.00 off that or I might as well just keep it as spares .
Thanks . Matt . 07733137231 . S.E London . .
Thanks . Matt .07733137231 . S.E . London .

Spitfire Close Ratio 1850 Gearbox Freshly Rebuilt

Mon, 23 Apr 2012 11:04:29 +0000

Just really fishing for interest,

My time and interest in the spit have dissolved at the moment, but im not gonna let it rust away and the bonnet has rust appearing so i need some readies to help repair it.

It has been fully rebuilt complete with all new bearings, thrusts, syncros and gaskets. I have the receipts for all the bits, there is hundreds of brand new bits in it.

It also has the last out the batch of custom input shafts to run the 1850 box on a spitfire.

Brand new clutch slave cylinder, electric speedo sensor.

Never been run, dry stored for the last two years as i lost my mojo.

If you want to use the mechanical speedo you will need to replace the plastic drive gear on the main shaft and it really needs an alloy bell housing for a spit to make the most of it. Pictured bell housing is the 1850 one which is different, i can supply it with a steel bell housing or without to save postage costs.

It cost me over £500 to build, obviously im gonna loose money, but make me an offer, bear in mind, there aren't any other input shafts like this, for any classic race series this is a period mod.

For Sale Gt Gareth Thomas Ported Cylinder Head, Exhaust Manifold

Fri, 20 Apr 2012 21:05:56 +0000

Hi I'm selling my Gareth Thomas Ported Cylinder head. This has special valves etc and will be good for 130bhp in a small crank engine and the correct cam. I'm also selling the Gareth Thomas Exhaust Manifold which is needed to extract the power to its full potential.

Cylinder head 10.5 compression ratio very good casting. £500 comes with new valve guides being fitted as we speak and freshly cut valve seats.

The Exhaust Manifold i'm after £500 and will include the connector pipe and the 2" large bore single silencer exhaust system.

Cheers Chris.

Type 9 Gearbox Conversion Parts.

Fri, 20 Apr 2012 17:47:04 +0000

Hi I'm now bolting my type 9 gearbox to a zetec so my triumph conversion parts are up for grabs.

Friction plate for large crank 1300 with ford type 9 splines.

Alloy spacer converter.

Alloy Bell housing much lighter then the cast lump, this has been repaired in the past but is now perfect for the job.

£200 delivered.

Cheers Chris.

For Sale 1300 Large Crank Short Engine Balanced/lightened Tr5 Cam

Fri, 20 Apr 2012 17:39:25 +0000

Hi all because of a change of direction with my car my rebuilt 1300 large crank engine is up for sale. Only bit not included is the cylinder head its self. You get the rockers(reconditioned) push rods,water pump & housing and the short block itself with a Canleys tr5 profile cam. The engine has done 9,000 miles since rebuilt at 70bhp. Its lightened and balanced and comes with a new clutch pressure plate but you will need the friction plate. It also has a old stock duplex kit fitted as this was going to be a fast road engine. Any questions please ask. If not sold will be put on ebay. Price to clear £500 collection from near Edinburgh.

Cheers Chris.

Triumph Tune Weber Manifolds

Fri, 20 Apr 2012 17:32:36 +0000

Hi all as you know a change of plans will now see me selling a pair of Weber manifolds. Price £100+ postage. If not sold will be put on ebay.

Cheers Chris.

Wanted - 1500 Cylinder Head

Fri, 23 Mar 2012 23:29:36 +0000

Could do with obtaining something locally to run on my car to keep it on the road whilst my own head gets worked on. Anyone got one near Yorkshire?

Wanted Triumph Herald Chassis

Sun, 18 Mar 2012 20:29:17 +0000

As the title says, i'm looking for a chassis for a 1971 Herald. Main rails need to be solid, Outriggers in good condition prefered but not essential.

Triumph Le Mans T6 1800 Vvc

Sun, 18 Mar 2012 13:37:53 +0000

anyone want a car that wont rot ebay item no 120877947138
has reserve price on it ?

Sure Hope Classic Cars Aren't Next.

Mon, 12 Mar 2012 23:22:17 +0000

http://epetitions.direct.gov.uk/petitions/22251

Wanted, Front Wishbone Lower Brackets

Mon, 05 Mar 2012 16:40:41 +0000

Does anyone have some spare front lower wishbone brackets for the Spitfire/Herald/GT6/Vitesse for sale? I need one front bracket, 130757 and two rear brackets, 130758, but will take a set of four if prefered.

Thanks.

Corbeau Sportsman Reclining Spitfire Gt6 Seats

Fri, 02 Mar 2012 18:10:40 +0000

Hi all for sale is a pair of corbeau sportsman recliners. They are used but in very good condition and are for Spitfire's and Gt6's. I'm sure they will fit other stuff but you can check the dimensions on the makers site.

Price is £250 and I will be traveling to stoneleigh triumph spares day so could deliver for free.

Cheers Chris.

Wanted, Spitfire/gt6 Rear Wing Trims

Mon, 27 Feb 2012 21:43:03 +0000

Does anyone have a spare pair of rear wing top trim pieces for sale? They need to fit the Spitfire MkIV/1500 and GT6 MkIII shape.

Collection from Stoneleigh this Sunday would be great as it avoids the trouble of postage and the risk of damage.

Hot Rod Herald 1200

Sun, 19 Feb 2012 11:14:27 +0000

Item number: 330686387375 finishes today